Install pictures

Install Pictures...


Tools required: Shovel, hammer and nails, level, drill gun and tape measure Materials needed: Concrete or sacrete, rebar, tie wire, 2x4's or 2x6's and a piece of plywood.	Site preparation. Dig hole to specifications provided in engineered foundation drawing provided, frame hole as shown. Run electrical to hole.	Anchor bolts, rebar and plywood panel. Paper pattern provided for drilling through plywood. Anchor bolts shipped before sign is shipped. Connect rebar to anchor bolts as shown with tie wire.	Picture of prepared foundation. Ready to pour concrete. Note electrical stub at far end of piece of plywood.

Close up of anchor bolts, rebar and electrical stub.	Smoothing concrete after pouring.	Foundation poured. Form removed. Ready for sign.	All done.
	When we receive photos of an installed sign, we are greatly appreciative. Installation photos help others understand that they too can install their sign when allowed by the local ordinance and save on their sign investment.	The hardest part is identifying your install "team". You CAN do it !

Additional photos...

Installation of premier model sign into brick wall


Forming columns	Removing forms	Adding cinder blocks	Ready for facings	Ready to set sign	Adding cross	All done
Two ladies show they are more than capable...

Digging hole	Drilling through template	Putting nit on J-bolt	Putting J-bolts through plywood	Securing J-bolts	Securing plywood for pouring concrete	Note electrical stub
You cannot over-engineer... it is YOUR project !
					Yes... You can do it yourselves...	...and save !
LARGE rebar cage	Base prepared	Pouring concrete	Pole with plate	Setting in place

Copyrights 2007 Cornerstone Companies LLC Cornerstone Companies LLC 800-456-9371 America's Premier Sign Provider